Generating your own energy pellets by means of a house pellet mill has a lot of appeal to some individuals. Owning your own abode pellet mill can bring more than a few reward. Firstly you can manufacture your own fuel from the resources you have available to you. This maybe local sawdust, or even straws, grasses and even cardboard plus paper. Generating your own fuel pellets cannot only bring a source of fuel independence, it can also generate some additional income. Most small residence pellet mills manufacture around 100 kilograms an hour. Since most homes only use between 3000 in addition to 5000 kilograms in a year, even a small abode pellet mill has the ability to make much more than the owner would require. This brings some options, either the pellet mill could be a group buy between an collection of pellet users, or one person could produce the pellets as well as sell the pellets back into the local area.
Learn more about Home Pellet Mill
At PelHeat we provide a consultation service on pellet production equipment, including some pellet mills suitable for dwelling use. To produce good quality pellets, your raw material requires certain properties. First it must be in small particles of either 6mm or below. The raw material must also be fairly dry. Though some moisture is required for the pellet process to work. Finally to manufacture consistent quality pellets, it is important to provide the pellet mill with consistent quality raw material. In this sense pellet production is much like cooking, and will take a few tries to get it right. To find out more please visit the PelHeat website. Generating wood pellets is not just always about only the pellet mill, it depends on what your raw materials is like. For case if you wish to process logs into pellets there are several stages of size reduction which must take place first. Firstly the log must go because of a chipper. Once into chips, these must also be reduced in size, therefore the chips are then placed in a hammer mill.
Read more about Pellet Mill Manufacturers
Due to high speeds of the hammers impacting on the wood chips, the chips shatter into small particles. A hammer mill has an internal screen, to challenge oversized particles from escaping the hammer mill until a 6mm particle size is achieved. The particles are then take from the base of the hammer mill by a fan and then separated from the air stream via a cyclone separator. The particles are now small enough for the pellet mill. On the other hand the particles must also be dry sufficient. There are quite a lot of drying solutions used depending on the productivity required.
The two main drying solutions are pipe dryers and rotary drum dryers. Smokestack dryers carry the wet particles in a hot air stream to remove moisture. Smokestack dryers are a very cheap drying solution, though they cannot cope by way of high moisture content materials.
More information on Biomass Bioenergy
