Alternative Energy HQ

Garages Issues: Steel Construction

Positive properties of steel designs of factory manufacturing can be used at building of garages; they are, as a rule, have small cross-section cutset and small building height, the big bay and small weight, provide easy and fast installation under any weather conditions, and also they have an opportunity of full dismantling of all components; an opportunity of full dismantling of steel construction allows to replace it to other place if the actual requirement for storage places considerably differs from planned requirement.. Steel designs often allow receiving economic decisions when the project as a whole is thought well over taking into account loadings on the basis and possible planning changes (multiple expansion, escalating or reduction on a vertical, etc.). Such designs are rather suitable for constructions in a city.

Mechanical devices, including their mobile parts and a bearing skeleton, are almost always carried out from steel.

The important precondition is the complex account of all features of work of a construction prior to the beginning of manufacturing of steel designs at factory. Modification of a design though does not cause technical problems, however interrupts process of serial output, leads to additional expenses of time and raises a project cost.

During manufacturing of designs at factory can already be carried out preparatory works on the place of building. It is expedient to begin bringing and installation of designs only when all details are already ready. Existing elevating mechanisms (truck cranes, tower cranes) and techniques of connection of designs provide their fast erection without negative influences on the environment, constructions and transport, which are located near the building. On very close building sites, for example in the city center, delivered large details can be established in the necessary position directly from the crane. Thus necessity for intermediate warehousing disappears and the number of lifting on a building site decreases, exact observance of terms and an installation rhythm however is required.

The sizes of large details are constructed by elevating mechanisms, and also the chosen vehicles and access roads (the open or curvilinear sites). In standard cases the length of elements should not exceed 20 m, width of 3,5-4 m, height of 3 m.

At manufacturing of bearing structures of open garages from steel it is possible to refuse the device of fire-prevention protective facing. In all other cases as recommended protective actions such as: concrete casting of columns and beams; at the corresponding constructive decision, for example installation of ferro-concrete elements with rigid armature, bearing ability of a construction raises; daubing: cement plaster with vermiculite, perlite or asbestos, cast plaster or modular shaped details and plates are applied; drawing on beams and columns of fire-resistant coverings, including foaming under the influence of heat; protection of support of coverings and beams with finish coat (plaster, plates); application of sprinkling installations and water hoses.

If you need portable car garage – this site will help. Lots of samples of car garage products and direct access to the car garage sellers. All contact info on the site.

P.S. And don’t let laziness to stop you from finding the best deal about car garages. Don’t forget that we are living in the world where info makes life easier.

That is why if you are properly armed with the info in your topic you can be sure that you will always find the way out from any bad situation. So, please make sure to visit this blog on a regular basis or – an ideal solution for you – sign up to its RSS feed. In such an easy way you will have a direct shortcut to the latest informational updates here. Blogging can be helpful, you just need to understand how to use them.

Exit mobile version