Pellet stoves like any heating equipment need some attention from time to time to keep them running efficiently. There are general points of maintenance, and there are also on old stove parts which may fail. In terms of general maintenance, there are a few key areas to focus on. Firstly the general day to day job of checking how much fuel is within the pellet stove hopper. Depending on the size of the hopper on the stove, it may requiring filling every day or every few days. Then a daily check on the amount of ash there is in the bottom of the stove, in addition to ash bin. Again how frequent you really have to do this will change depending on the size of your ash bin, plus type of fuel pellets you have been using. A yearly check should actually be manufactured on the burn pot itself. As the burn pot is at the heart of the combustion process, it is subject to extremely high temperatures, at which corrosion rates are accelerated as well as it may require repair.
Click Here For Your Pellet Stove Guide!
The increased corrosion risk also goes for the warmth exchanger. The heat exchanger is where the combustion gases leave the fire, in addition to heat is transferred into the heat exchanger before the gases leave to the smokestack flue. How the rate of corrosion effects the burn pot in addition to heat exchanger depends on the quality of the pellet stove along with materials used. For case, at PelHeat we burn large quantities of straw pellets which are highly corrosive. Therefore the warmth exchanger on our pellet boiler is double the thickness of the steel used on most pellet boilers. The same also applies for the burn pot which is made of cast fire brick. Other than the burn pot as well as burning chamber, the auger feed and hopper necessitate yearly maintenance, along with may require repair. On some lower quality pellet stoves, the auger drive system, auger or auger motor may require replacement or repair. Some designs of auger rely too heavily on perfectly sized pellets of a perfect density. Yet some pellets are longer in addition to hard, in lower quality pellet stoves this can cause the pellet feed auger to block in addition to even break. The construction should provide the parts for the repair.
As by means of any product, there are lower and higher quality products available. Where with some purchases it may create sense purchasing the cheaper lower quality item, this is not the case in point by means of pellet stoves. That is not to say that you should only buy the most expensive pellet stoves. More that there are certain features you should spend your money on, along with other features that are not crucial for a pellet stove to warmth your home or company effectively. Areas where it is important to spend more are on a better designed hopper as well as pellet feed system, by a robust auger motor as well as auger. A stronger pellet feed system will eliminate issues because of long in addition to dense pellets, that would make issues for other pellet combustion systems. The guide can help show how.
